UNSOLVED

thenikoos

updated

20 years ago

T

thenikoos

4 Posts

0

7022

April 15th, 2007 09:00

Problem using Dell PC Restore

Hello,
 
I'm having problems to use the Dell PC Restore on an Inspiron 2200.
 
I try to start the PC Restore by pressing ctrl+F11 as indicated in the manual but it doesn't do anything.
 
I checked if the partition is still existing with the DSR utility, it says that the partition is OK.
 
Is there any other way to start the PC Restore ? or to activate it?
 
Note: I don't have the dell cds anymore so I cannot reinstall my system from the disks.
 
Thank you for your answer.
 
  • dg1261

    623 Posts

    210

    0

    Posted April 15th, 2007 21:00

    Troubleshooting steps:

    (1) Are you sure you have a DSR (PC Restore) partition? When you boot into XP, take a look in Disk Management and look at the schematic "map" in the right pane. If you see an "unknown" partition about 3-5 GB at the end of the disk with no drive letter, that suggests your DSR partition is still there.

    (2) Do you have a Dell MBR? This is easily overwritten, so even if your system shipped with the Dell MBR, it might not necessarily still have it. The telltale sign of the Dell MBR is a black screen with a single blue line at the top, with "www.dell.com" in white-on-blue letters. This screen should appear for 2 seconds between the POST phase (Power-On Self Test, with the giant blue Dell logo) and the XP splash screen (when XP starts to boot).

    If the answer is yes to both, then make sure you're pressing Ctrl+F11 at the right time. When the POST phase starts, you'll see the blue Dell logo, there will be a brief delay, then the "F2" and "F12" prompts will appear in the corner of the screen. After POST completes, you'll see the 2-second blue-line. You must press Ctrl+F11 after the F2/F12 prompts appear, and before the end of the 2-second blue-line pause. Hold down the Ctrl key, press down the F11 key, then release both keys together.