Unsolved
2 Posts
0
1329
February 28th, 2020 21:00
FN410S SNMP setup
Just getting the FX2 setup and going. Unit has two FN410S aggregators installed. The aggregators are setup in full mode. Most everything is up and going as intended but I can't get SNMP v3 going. From everything in the CLI it appears this thing should support this, (it is 2020 after all) but I can't get it integrated into Solarwinds. I've looked high and low and can't find a configuration guide any newer than version 9.10.0 for this module. They are currently upgraded to the latest version 9.14.1.8. Any help pointing me to the needed documentation would be appreciated. We are using both authentication and encryption for read-only groups in SNMPv3.
No Events found!
DELL-Marco B
Moderator
•
3.9K Posts
0
March 2nd, 2020 07:00
Hello,
please find here an article that can help you
https://dell.to/2TyriiD
Thanks
Marco
kossuth78
2 Posts
0
March 2nd, 2020 08:00
This is helpful given this appears to be the info for the CMC module, but does this also apply to the FN410 modules as well particularly if they are installed in FULL mode?
DELL-Marco B
Moderator
•
3.9K Posts
0
March 2nd, 2020 09:00
Hello,
yes, it should be the same procedure.
Marco