did you configure default route ?

I have made my both data mover as primary, I want to create replication session.

But newly create interface showing in routing table.

Please could you give me the steps in order to create a replication session.

In simulator i can't see any SP's ip.

My simulator version is 5.6.

I have create an interface cge0_1 ip 192.168.10.10 in server_2.

And i have create an interface cge0_1 ip 192.168.20.10 in server_3.

I can see both network in routing table but i cant ping using server_ping server_2 192.168.10.10 from server_3 and vice-varsa.

Or need to add as default route list if yes please tell how to add through CLI.

here is the manual on how to use Celerra replicator. You need to make sure you have network up and running, otherwise replicator will not work as it's IP based product.

Using VNX Replicator  7.0 A05

you need to add the default route on both the data movers,

server_route server_x -add default

Check if you have added route for control station as well.

#cat /etc/sysconfig/network-scripts/ifcfg-eth3

Thanks a lot sameer.

Let me check once..