UNSOLVED

TF-9l6i4

updated

17 years ago

T9

TF-9l6i4

54 Posts

0

1546

August 14th, 2009 05:00

Deduplication

Kicked off dedupe on a 1TB file system this morning at 10:08am. More than 3 hours later and the properties on the FS are still showing not much activity:

Status: Idle (Waiting for next scan)

Statistics: As of last file system scan (Friday, August 14, 2009 10:08:02 AM BST)
Files scanned: 14
Files deduped: 0 (0% of total files)
Original data size: 19 MB (0% of current file system capacity)
Space saved: 0 MB (0% of original data size)

Have refreshed the screen (Celerra Manager) by clicking the green arrows as opposed to F5, but no change. Is this normal?

Does anyone know the CLI command to get the deduplication stats on a FS?

Regards
  • Peter_EMC

    674 Posts

    591

    0

    Posted August 14th, 2009 06:00

    please read the dedup manual and configure the dedup params accordingly.
  • jhamer1

    22 Posts

    591

    1

    Posted August 14th, 2009 06:00

    TF - Keep in mind that dedupe runs as a very low priority background process, so any other file system activity will take precedence and slow down the process. Also if your savvol space is low from snapshots the dedupe process can seem to take longer or hang and eventually fail to do lack of space.

    Since your status is showing idle, I would check the event logs to see if the process stopped due to lack of savvol space. If I'm enabling dedupe on a file system, I try to remove some or all of the existing checkpoints (if possible) before enabling dedupe the first time to avoid the problem.

    There are two commands I use to check dedupe status:

    fs_dedupe -list (List summary of all enabled file systems with basic stats)
    fs_dedupe -info (Detailed dedupe status for a specific file system)

    FYI - I have rarely seen the stats from the command line match the stats from the Celerra Manager GUI. Not sure which to believe, but the command line feels like more accurate numbers.

    Hope this helps. --Jeff

    Message was edited by:
    Jeff Hamer
  • TF-9l6i4

    54 Posts

    591

    0

    Posted August 14th, 2009 07:00

    Found the manual - for reference it's here.....

    Home > Support > Technical Documentation and Advisories > Hardware/Platforms Documentation > Celerra Network Server > Installation/Configuration \ Using Celerra Data Deduplication 5.6.43 A02
  • TF-9l6i4

    54 Posts

    591

    0

    Posted August 14th, 2009 07:00

    A bit more info.....

    I'm running the dedupe operation on a test 1TB file system, with zero active users.
    The file system is mounted on a NS702G that is only used to receive FS replications. No data is served out from this NAS box.
    There's 99% of the 36GB of Savvol dedupe manual" ?

    Thanks
  • TF-9l6i4

    54 Posts

    591

    0

    Posted August 14th, 2009 09:00

    Think I found my problem. As per the Dedupe manual....

    "If the file system is not configured to auto-extend, the deduplication process
    will abort if the file system usage is equal to or greater than 95%."

    And ours was 99% full......
  • Dimebag1

    19 Posts

    591

    0

    Posted August 19th, 2009 22:00

    server_log server_n helps me most of the time to see whats going on.