DMI creation using CLI

Question

I am creating DMI using CLI as shown below, Am I following the correct syntax? On the Source Celerra with the hostname EMC-Prod: nas_cel -interconnect -create Source-To-DR-DMI-source_server server_2 -destination_system EMC-DR -destination_serverserver_2 -source_interfaces ip=x.y.80.25 On the Destination Celerra with the hostname EMC-DR: nas_cel -interconnect -create DR-To-Source-DMI-source_server server_2 -destination_system EMC-Prod -destination_serverserver_2 -source_interfaces ip=x.y.120.25

SAMEERK1 · Answer

Hi, you are missing the destination interfaces from the command, Please refer the document 'Using Celerra Replicator V2' Sameer Kulkarni

Celerra

Was this post helpful?