dont worry

in setup_clariion speak User_Defined just means that you arent using array templates - it means that you are doing shelf-by-shelf configuration.

just run setup_clariion and it will tell you what's unconfigured and which raid layout options you have for each DAE. It wont configure a raidgroup before asking for confirmation and it never touches existing RGs/LUNs

I think it will only offer 6+1R5 for ATA or LCFC drives though

hmm...this is what i am getting:

[root@ns80 setup_backend]# ./setup_clariion2 setup APM000XXXXX
System 192.168.1.200 is up
System 192.168.2.201 is up
 
Clariion Array: APM000XXXXXX  Model: CX3-80  Memory: 8192
Argument ""255" isn't numeric in multiplication (*) at common.pm line 1593.
Argument "0"" isn't numeric in addition jivetokend81c2Otokenjive at common.pm line 1593.
Argument ""255" isn't numeric in multiplication (*) at common.pm line 1593.
Argument "0"" isn't numeric in addition  at common.pm line 1593.
 
Additional configuration of this shared storage may be required by the
SAN administrator.

and i am back at command prompt.

just tried that:

 
 
 
[root@ns80 sbin]# ./setup_clariion APM000XXXXXX
 
CLARIION(s) APM000XXXXXXX will be setup.
 
Setup CLARiiON APM000XXXXXX storage device...
System 192.168.1.200 is up
System 192.168.2.201 is up
 
Clariion Array: APM000XXXXXX  Model: CX3-80  Memory: 8192
Argument ""255" isn't numeric in multiplication (*) at common.pm line 1593.
Argument "0"" isn't numeric in addition jivetokenFx325xtokenjive at common.pm line 1593.
Argument ""255" isn't numeric in multiplication (*) at common.pm line 1593.
Argument "0"" isn't numeric in addition jivetokentq5PLntokenjive at common.pm line 1593.
 
Additional configuration of this shared storage may be required by the
SAN administrator.
 
 
Setup of CLARiiON APM000XXXXXXX storage device complete.
 
Discovering storage (may take several minutes)
done
[root@ns80 sbin]#

If this truely is an NS Integrated (not a NS80G gateway with a CX3-80) then just do (as root) /nas/sbin/setup_clariion APMXXXXX

I'm not sure why you would use setup_clariion2 - it isnt supposed to be run directly

Or just go on Celerra Manager (Celerras > Storage > System > Configure) which will do the same thing

yeah, we had a look at the config file but quotes have been there from the very first start. There are quotes on my CFS-14 as well ..but who knows, i opened a ticket just in case.

no I know

the fix is simple but requires editing a Linux config file so I dont want to post it here.

Just contact EMC Support and ask them to give you the instructions from Primus

emc176694 Why does setup_clariion -init on a NS20 give errors regarding subnet mask?

support fixed it ...he would not tell me what he did though.

chances are they just removed these quotes in the relevant config file

I guess your CFS14 runs a bit older DART - now for the FC enabled NS systems there were a couple of additional checks put into setup_clariion