This post is more than 5 years old
1 Rookie
•
71 Posts
0
555
October 1st, 2009 22:00
Usermapper of Secondary site in replication environment
Could someone please tell me what you recommend about the configuration of Internal Usermapper in replication environment?
Im not sure what we should configure about the Usermapper of Secondary site in replication environment.
Primary site is NS40G which is Active/Standby Datamover.
Server_2 is active datamover.Usermapper is configured "enabled" as secondary in server_2.
Server_3 is standby datamover.Usermapper is configured "uninitialized" in server_3.
Secondary site is NS120 which is Active/Active Datamover.
Server_2 is active datamover.Usermapper is configured "enabled" as primary in server_2.
Server_3 is active datamover.
Then, what should we configure Usermapper in server_3 on the Secondary site?
Thanks,
Yasushi
Im not sure what we should configure about the Usermapper of Secondary site in replication environment.
Primary site is NS40G which is Active/Standby Datamover.
Server_2 is active datamover.Usermapper is configured "enabled" as secondary in server_2.
Server_3 is standby datamover.Usermapper is configured "uninitialized" in server_3.
Secondary site is NS120 which is Active/Active Datamover.
Server_2 is active datamover.Usermapper is configured "enabled" as primary in server_2.
Server_3 is active datamover.
Then, what should we configure Usermapper in server_3 on the Secondary site?
Thanks,
Yasushi
No Events found!
Peter_EMC
674 Posts
0
October 1st, 2009 23:00
the configuration of Internal Usermapper in
replication environment?
Im not sure what we should configure about the
Usermapper of Secondary site in replication
environment.
Primary site is NS40G which is Active/Standby
Datamover.
Server_2 is active datamover.Usermapper is configured
"enabled" as secondary in server_2.
Server_3 is standby datamover.Usermapper is
configured "uninitialized" in server_3.
Secondary site is NS120 which is Active/Active
Datamover.
Server_2 is active datamover.Usermapper is configured
"enabled" as primary in server_2.
Server_3 is active datamover.
Then, what should we configure Usermapper in server_3
on the Secondary site?
Thanks,
Yasushi
There should only be one primary usermapper, if this are not different AD domains.
on the Secondary site?
as a secondary usermapper
yasush1
1 Rookie
•
71 Posts
0
October 2nd, 2009 00:00
I got it.
I appreciate your help.
Thanks a lot,
Yasushi