info regarding flare upgrade for using mirro view

Question

We are planning to implement mirror view in our environment. Can any one suggest me the best practice that we need to have the flare versions between the primary and secondary mirror.

DGM3 · Accepted Answer

You may wish to review the Release Notes for MirrorView, on Powerlink at;
Home > Support > Technical Documentation and Advisories > Software ~ J-O ~ Documentation > MirrorView > Release Notes

The "Interoperability" segment near the front to the Release Notes should be helpful.

It may also help if you could provide some additional context about your intended configuration, such as which type of mirroring (Sync or Async), and what array models would be deployed.

Regards,
DGM

RRR · Answer

It's best to have the Flare's not further appart then 1, so Flare 24 and 26 is ok, 19 and 22 is ok, 26 and 28 is ok.Other configs work, but EMC recommends to keep them close.

rgunda · Answer

Thank You

rgunda · Answer

Thank U RRR

rgunda · Answer

Thank You very much and the thing is we are planning to do some migrations using mirror view from cx500/700 to cx3-80. what method you would suggest? (mirror view/A or mirror view/S)

CLARiiON

info regarding flare upgrade for using mirro view

Was this post helpful?