This post is more than 5 years old
9 Posts
0
2924
August 20th, 2008 08:00
NDU software list - active vs. enabled?
For packages that require a license (enabler), is there any way (GUI or CLI) to find a list of which packages have the enabler? I've recently started a job where we have a CX3-80 with FLARE 26, and have looked at Navisphere, SP collects, NST, etc. and have found a number of "surprises". However, while the NDU list shows lots of goodies as "active", like SAN Copy, apparently some or all of them are not licensed. I can't seem to come up with a way to list them, if any. Maybe that's the problem - if there were any enablers, should they show up in the NDU list? Navisphere Analyzer works but there is no enabler listed for that....
No Events found!
countzero1
9 Posts
0
August 20th, 2008 11:00
Ah, if you saw the other thread I started yesterday (which I don't believe anyone has responded to yet), I was getting spurious error event emails from the CLARiiON monitoring agent, and at least one (0x2580) is known to be innocuous. So, I was in engineering mode to modify the template and turn off that event.
I still would like to know if the other codes I'm getting are in the same "noise" category so I can turn them off too.
Thanks for the help!
AranH1
2.2K Posts
0
August 20th, 2008 11:00
countzero1
9 Posts
0
August 20th, 2008 11:00
"Fix: The event number 2580 should be unchecked in the monitor template. According to EMC Engineering, event 2580 event is always called during an SPS test even if the SPS has no problems. That is why this event is not monitored. If there is a problem with the SPS, a subsequent event will identify the problem and dial home.
Note: Navisphere may need to be in engineering mode in order to access the template properties."
So, rather than fight with it, then find out I needed to be in engineering mode, I just went in.
Turns out, you are right - these advanced monitoring options are available in normal mode. So why did they say that? Doh....
AranH1
2.2K Posts
0
August 20th, 2008 12:00