Hi it is an AX4 backend.

Can you please tell me where I find the NAS CODE and FLARE version.

Thank you.

Hello ,

Welcome to EMC support forum.

Can you please let me know if its a NX4 with AX4 backend.. Also can you please let me know the NAS code version and the FLARE version of the box .

Regards

Vanitha

Sorry here are the informations.

.

Hi,

could it be here a problem, that one of my Management IP adresses is not pingable from my workstation?

Please open a Service Request with the support through Powerlink. In this case the support will have to analyse the SP Collects and would get back to you with the workaround.

I think in this case Co-Herency and Src-Route Attempt needs to be checked.

Thanks

Hi ,

Please verify your Peer SP Status that it is working fine(Check for any amber LED on the SP/Storage). If the SPs are working fine, kindly verify the network connectivity to the SPs.

Hope this helps.

Vipin V.K

Check for network connectivity, cables and the switch port if the SP is working fine. Otherwise check the SP if there is any amber LED on it (Verify the SP is is powered up).

Vipin V.K

HI,

yes I can manage one of my two interfaces.

Figured it out, a cable was broken on one of my SPs.

Are you able to log in to the set up page.

http:// /setup

Hi,

You should be able to access both the interfaces. Please verify the network connectivity, or SP status physically as discussed.

Vipin V.K