This post is more than 5 years old
23 Posts
0
1129
March 3rd, 2009 10:00
SAN COPY, pull from CX4 and CX300
Hi,
i have to perform a migraton from one CX300 to one CX4-120.
On the CX4 there is sancopy, so i want to use this software and perform a pull operation.
Now the question.
I can see the CX4 that register and login itself on Connectivity Status of CX300 and this happen after i run the command -sancopy -updateconnecion on the array.
But i can see the login and registration of the CX300 on CX4 and if I try to perform the same command i have this error:
NaviCLI.exe -h 172.16.3.217 sancopy ¿updateconnection
Error: sancopy command failed
This version of Core Software does not support SAN Copy
Obviosly due the fact that on this array there isn't sancopy.
In wich way can i have the registration of the CX300 versus CX4?
i have to perform a migraton from one CX300 to one CX4-120.
On the CX4 there is sancopy, so i want to use this software and perform a pull operation.
Now the question.
I can see the CX4 that register and login itself on Connectivity Status of CX300 and this happen after i run the command -sancopy -updateconnecion on the array.
But i can see the login and registration of the CX300 on CX4 and if I try to perform the same command i have this error:
NaviCLI.exe -h 172.16.3.217 sancopy ¿updateconnection
Error: sancopy command failed
This version of Core Software does not support SAN Copy
Obviosly due the fact that on this array there isn't sancopy.
In wich way can i have the registration of the CX300 versus CX4?
No Events found!