Unsolved
This post is more than 5 years old
77 Posts
0
417
February 1st, 2008 08:00
DS4700-M backup - no management port
Hi,
My network management port on the switch is down so we are replacing the switch. The issue is I do not have a backup. I would have liked to have dumped the configuration to the new switch. I noticed there is a serial port on the back of the switch. Can I get a configuration backup this way and if so how? I am a relative newbie at this so any guidance provided would be greatly appreciated.
Thank you,
happyadm
My network management port on the switch is down so we are replacing the switch. The issue is I do not have a backup. I would have liked to have dumped the configuration to the new switch. I noticed there is a serial port on the back of the switch. Can I get a configuration backup this way and if so how? I am a relative newbie at this so any guidance provided would be greatly appreciated.
Thank you,
happyadm
No Events found!
Mabro1
2 Intern
•
666 Posts
0
March 27th, 2008 08:00
I am the moderator for this forum and I notice you have not yet received a reply or answer to your question.
Unfortunately I do not have the technical information required to answer your question. I would advise you to log a Service Request with EMC through our PowerLink website, if this issue is urgent in order to get a more prompt response.
Kind regards,
Mark Browne