Data Domain Mount CIFS share

Question

Hi there, I'm trying to mount a file share that I've created on a DD VE but I can't seam to workout the authentication. The appliance isn't registered in AD so I have tried using the sysadmin password which I'm 99% is right, I think the issue is what domain I should be putting in. I have put in workgroup but that didn't work, any ideas? Thanks, Ed

dynamox · Answer

share permissions configured correctly ?

edhoward · Answer

I figured it out in the end, I used the IP address of the Data Domain as the domain along with a local account username and password.

I have another issue now in regards to replication. I have pared both systems and set up the replication which appears to go through all the steps correctly but straight after I get the following issue.

Replication: cannot connect to TPS-DDVE01.local. No such file or directory

Screen grab: Image.

These are in two different locations but on the same sub net but on different networks. They should be able to talk to each other though I am getting someone to check that the ports are open.

Any ideas?

Thanks

dynamox · Answer

can you telnet from one to the other on port 2051 ?

edhoward · Answer

I'll have to have a go at that tomorrow, what if I can't?

edhoward · Answer

The systems connect so they must be able to ping, the issue is that the replication will not work properly.

edhoward · Answer

Hi there, Yes we can Telnet from one to the other. Thanks Ed

Data Domain

Was this post helpful?