Start a Conversation

Unsolved

DR

3 Apprentice

 • 

900 Posts

19

April 22nd, 2024 16:44

cannot discover switch with only ssh

I have two Dell 5248 switches and recently installed OME 4.0.1 build 29. I dont want to use SNMP to discover my switches, so in the discover, I select Network Switch, I give it the IP of the switch, then in "additional settings" I deselect "Discover using SNMP" and populate the SSH info and click Finish. The job runs and instantly fails. if I use SNMP and SSH, it works just fine. The networking is set correctly, I can ping the OME VM from an outside source so I know the GW is working. It would be nice if OME had a ping test screen so that we can confirm that OME can ping out to a specific IP address (in this case, the GW). 
#Iwork4Dell

1 Rookie

 • 

5 Posts

May 6th, 2024 15:25

Hi,

OpenManage Enterprise does have an option for Ping Test .
Please Navigate to Monitor>>Troubleshoot Page.
On the Device Tab , enter the IP address/hostname of the target device (By selecting Ping Device option)
Click on Test.

Regards,
Soumyajeet
#Iwork4Dell

1 Rookie

 • 

5 Posts

May 6th, 2024 15:55

Hi,

Additionally , Switch discovery Over SSH is not supported.
Here is the Discovery Support Matrix.

Regards,
Soumyajeet


#IWork4Dell

No Events found!

Top