Deploy Template

Hi, thanks for choosing Dell. Would you be able to attach a screenshot where you see an error message / where you fail? 

There are no errors, I applied template first time with no issues, when I try to apply template second time to same server,  server is not available for selection.

Hello,

which version of OpenManage Enterprise are you using?

Thanks
Marco

OpenManage Enterprise 3.6.0 (Build 41). Tried to reboot, it didn't help. It used to work fine applying template to same servers multiple times.

What troubleshooting steps have you taken thus far? Has the appliance only just started showing this behavior, or is this a new appliance that you're seeing this with? Finally, just for my own clarity, what are the differences between the first template that was applied successfully and the second that won't allow you to apply it? Or are you saying these templates are the same?

I did reboot OME server, rebooted DRAC, removed servers from OME and rescanned added back. The only difference between templates is logical processor enabled/disabled. Same issue when try apply template to other servers, it worked for first time, OME doesn't allow select to apply template second time.

Has the old template been removed, or were you trying to go straight into deploying a new template? Profiles can lock you out of reconfiguration, so you might try going into Profiles > Configuration and removing the old template, if you haven't. 

I created new template from model device.

Also have this issue.
OME Version 3.10.2 (Build 13).