Unsolved
1 Rookie
•
72 Posts
0
269
June 29th, 2021 04:00
Discovery using a IP range - CGEN1013 - completed with errors
Hi,
Is it normal that if you use a IP range during discovery,
that the IP's that are not in use will give a "Failed" status and the job status always has a "Completed with errors" status?
.20 & .21 are iDracs
all other IP's are not in use
No Events found!
Dell-DylanJ
4 Operator
•
2.9K Posts
0
June 29th, 2021 09:00
Hello,
I don't have an environment configured to test this, but I do believe this would be completely normal. The message "completed with errors" will populate anytime a job isn't wholly successful on every task. With .20 and .21 being the only iDRACs, they're the only things responding with the expected data, the other addresses are addresses OMEnt is expecting data from and not receiving it (because there aren't iDRACs there).