At the bottom of the screen there should be some small text allowing you to change modes. "Manage Remote System" is what I believe it said when going the other direction from what you're wanting to do.

However, I need to clarify something to help understand the situation. Did you install OpenManage for this host on a VM or the host itself? If it is a VM, the OpenManage instance is not going to see the iDRAC and it's associated data. The OpenManage .vib would need to be installed on the host itself, and then another OpenManage instance can be pointed at the IP of the host. For example, you could install the .vib to ESXi, then use a laptop with OpenManage to view the server information. 

Your description is leading me to believe that the installation wasn't done on the host, and would explain why you can't pull data. But if I am mistaken, you should be able to toggle the mode in some small text below what you see. I'll see if I can locate a screenshot.

Hello Dell-DylanJ,

Thank you for your response. The installation is made on physical host:

As you can see below in red square there is button(Manage Web Server) to switch the mode but it leads to page where I can't find anything useful:

In comparison I have another server where the switch button is "Manage Local Node" and here everything is OK:

Also problematic Openmange have version 6.5.0 and normal one 7.1.0.

Can this problem somehow connected with Openmanage version?

Is it possible that there are different modes to install Openmanage and the "problematic" one was installed in "only manage other nodes" mode?

Both of those OpenManage versions are pretty out of date. what I would try is uninstalling them, then installing the latest iteration supported by your server model. If it is an 11G or earlier, that should be 8.5. If it is 12G to 14G, it should be 9.2. 

Hello Dell-DylanJ,

Thank you for your support.