For some reason the secondary module states a solid amber on the LED and PWR is green.
The solid amber as per the dell guide, that its functioning correctly as the secondary module?
But the GUI still states that no controller module is installed. None of the eth ports are flashing.
Have connected a serial cable but then it errors out and now the amber light is gone.
The Event log came back and stated control module has been installed - and then immediately after it states it cant communicate with the primary controller.
Then it has successfully designated itself as a secondary and then states C2F power module is not operating, C2F power module has insufficient hold time.
Any help would be much appreciated, will purchase another controller if required, just weird that it works and than errors out.
matthewdaniels
2 Posts
0
April 18th, 2017 19:00
Hey Donald,
Thanks for the response!
For some reason the secondary module states a solid amber on the LED and PWR is green.
The solid amber as per the dell guide, that its functioning correctly as the secondary module?
But the GUI still states that no controller module is installed. None of the eth ports are flashing.
Have connected a serial cable but then it errors out and now the amber light is gone.
The Event log came back and stated control module has been installed - and then immediately after it states it cant communicate with the primary controller.
Then it has successfully designated itself as a secondary and then states C2F power module is not operating, C2F power module has insufficient hold time.
Any help would be much appreciated, will purchase another controller if required, just weird that it works and than errors out.
Cheers