Are you talking about using the EMC CEE software? If so, look in your Isilon admin GUI Guide under the Audit section for the version of OneFS you have on your cluster and you should see the poorts used for the EMC CEE client.
So I have the port (12228) frm thje isilon to the CEE server, but then the CEE server sends the data on to Varonis. (in our case).
From Varonis I got this info:
"As you confirmed, port 135 is used for the initial call to the CEE/CEPA server.
From there, any one of the ports within the standard dynamic port range is utilized. I may have mentioned before that I can't speak to why any particular port is selected from that range, but it will always be between 49152 and 65535. In this case we see that the port used is just a bit higher than the low-end of the range."
dfelt1
34 Posts
1
June 6th, 2017 13:00
Hello,
Are you talking about using the EMC CEE software? If so, look in your Isilon admin GUI Guide under the Audit section for the version of OneFS you have on your cluster and you should see the poorts used for the EMC CEE client.
sysadminbb
4 Posts
0
June 7th, 2017 05:00
So I have the port (12228) frm thje isilon to the CEE server, but then the CEE server sends the data on to Varonis. (in our case).
From Varonis I got this info:
"As you confirmed, port 135 is used for the initial call to the CEE/CEPA server.
From there, any one of the ports within the standard dynamic port range is utilized. I may have mentioned before that I can't speak to why any particular port is selected from that range, but it will always be between 49152 and 65535. In this case we see that the port used is just a bit higher than the low-end of the range."