Hello,

 

What you might look at doing is rebooting the chassis and logging into the F2 BIOS. There should be an iDRAC settings menu. You should find an option to reset the iDRAC to it's default settings. The defaut username and password are root and calvin, per the documentation for the F200 and F600. 

 

I also noticed in the manual a warning that the iDRAC features and functionality may not work as intended inside OneFS. I found this on page 12 of the manual.

 

Let me know if this helps, or if you have further questions.

Thank you very much reply.

Which Manual?

 

The Node Installation Manual.

 

https://dell.to/3g5mTgr

The PowerScale Node Installation Guide is available at Dell Online Support. 

The note referenced in the previous reply, reads:

NOTE: Although iDRAC is preinstalled in F900, F600, and F200 nodes, caution is recommended when using iDRAC. Some
iDRAC features and functionality are accessible with the iDRAC interface, but are not supported. OneFS only supports the
following IPMI commands with the iDRAC interface:
● Shutdown (power off)
● Reboot (power cycle)
● Startup (power on)
● Power Status (read-only)

@mawatarai 

I have seen the iDRAC password is in the back of the node on a sticker.

https://qrl.dell.com/Files/en-us/html/Manuals/R640/Locating%20your%20system%20Service%20Tag=GUID-E640B915-460E-47DA-ABAE-D85966894CAC=2=en-us=.html