UNSOLVED
E173FP, 2005, blank
Monitor goes blank almost immediately after switching on. Switching it off, leaving for a few seconds and back on gives the data from the PC sowing but almost immediately goes blank.
Following the suggested checks some years back gives a short flash of white when operating the on/off switch with no power attached. Replacing power and switching on gave the word Genesis for half a second and a blank screen after that.
Switching off and then on again gives the Self Test blocks that disappear almost immediately.
Where would the fault lie and how do I remove the casing - there is no obvious way?
(edited)
0
0
Posted January 27th, 2025 17:31
I input serial number and Model number of the Monitor into the I Dell form and both came up as not found. It is old - says made 2005.
0
0
Posted January 27th, 2025 18:55
Post a picture of the rear label.
DELL-Chris M (old account)
#IWork4Dell
0
0
Posted January 29th, 2025 11:21
@DELL-Chris M Thanks Chris. Here is the back of the monitor
0
0
Posted January 29th, 2025 12:07
@mike533 Probably not worth the bother, suspect the ics won’t permit easy replacement of parts. Replacement already purchased but hate to throw away if repair had been possible, although invariably more expensive than new one if I can’t do it myself.
0
0
Posted January 29th, 2025 14:36
Based on the current E173FP eBay market value $20 to $35, not worth trying to repair.
DELL-Chris M (old account)
#IWork4Dell
DELL-Chris M
Community Manager
•
56891 Posts
•
232143 Points
0
0
Posted January 27th, 2025 16:03
What monitor model? There should be a label on it notating build date and monitor model. Unknown as to what component has failed.
(edited)
DELL-Chris M (old account)
#IWork4Dell