Add Networker Client Failed

Question

When i want to add client on networker, i am getting alert like this. 'connecting to host failed. unable to connect to server. remote system error - a connection attempt failed because the connected party did not properly respond after a period of a time, or established connection failed because connected host has failed to respond'. Then i check nsrexecd service on my vm, but the service is running. I check the firewall, the firewall is disabled. so i want to ask, what is the problem? why i cannot add the client?

bingo.1 · Answer

To configure a client only his hostname must be resolved. You can verify that easily if you enter a fake entry in your hosts table.

Next you should try to connect via this command: nsradmin -p nsrexec -s

where ' ' represent the NW host at the other side, i.e.

- if you run the command on the NW server, = NW client

- if you run the command on the NW client, = NW server

Don't proceed if this is not working.

NetWorker

Was this post helpful?