Unsolved
This post is more than 5 years old
13 Posts
0
1017
November 9th, 2011 02:00
homebase PXE boot environment
hi,
Im trying homebase, so i have an evaluation licence.
i would like to deploy a boot PXE test. To do that i enabled
TFTP and DHCP service in HB.
I tried to boot PXE from a virtual machine the machine detect the dhcp and the tftp
but i have an error message
help please !!!
ble1
4 Operator
•
14.4K Posts
0
November 9th, 2011 14:00
I didn't play (yet) with PXE based DR, but are you sure deplyment server is configure? (see link). By looking at it, it looks as your deplyment server is returning this message. I know Windows team tested it here where I'm now and they were happy with it, but since they did isolate test I was not involved so I do not have all details of configuration they made.
mehdi-mkacher
13 Posts
0
November 10th, 2011 01:00
ok, So i need a deployment server to have a PXE environment ?
because in my case i tested HB in windows 2008 server and the querstion is, if i have a linux machine in wich i installed HB what should i do ?
ble1
4 Operator
•
14.4K Posts
0
November 10th, 2011 02:00
Ah sorry, I just figure out you are running HB... I though you were referring to NW DISASTER RECOVERY saveset. I'm not sure if there is a difference when using HB, but I suspect (guess) there isn't. I'm not familiar with H, but I remeber TFTP was one of possible protocols to be used to access PXE boot image from HB server so I assume (guess again) that one would be used in case you would have Linux HB server with PXE image stored (not sure if that works, but I see no reason why it shouldn't). Not sure if anyone else has worked with HB here and if it can give more details and real life experience...