dvdetect is spawned by ddmg and from what I see they way you run it it was not instructed where the server is.
Try to use more low level commands like inquire and sjirdtag. sjirdtag should be able to connect to your lib over control port and see if it lists content - if not, something else is wrong.
bingo.1
2.4K Posts
0
January 20th, 2016 09:00
Have not done that for a while but I assume you must specify the server as if it is not running on the storage node.
This would explain this message:
>>>> 7842:dvdetect: cannot connect to NSR service on emcmedialnx
usage: dvdetect [-s nsr_server] [-h host prefix] [-x SCSI target] [-d] [-l] [-p] [-N ndmphost]
BTW - You are setting up a test environment. May I suggest that you use the latest NW 8 version (NW 8.2.2.3).
ble1
4 Operator
•
14.3K Posts
0
January 20th, 2016 09:00
dvdetect is spawned by ddmg and from what I see they way you run it it was not instructed where the server is.
Try to use more low level commands like inquire and sjirdtag. sjirdtag should be able to connect to your lib over control port and see if it lists content - if not, something else is wrong.
crazyrov
4 Operator
•
1.3K Posts
0
January 20th, 2016 21:00
Are you using MHVTL ? IF so then check the configuration on the MHVTL and try again, As it might an issue on the VTL than on the networker or OS .