Unsolved
This post is more than 5 years old
3 Posts
0
850
September 17th, 2015 01:00
Restore Exchange 2007 with Networker Module for Exchange 5.1.3
Hi everyone,
I have a question with Networker Backup Exchange Server 2007
Our system has one server run Exchange Server 2007 SP3 all-in-one, one server run Networker 8.2 for backing up all our system.
To backup email system, i installed Networker Module for Exchange v5.1.3 on Exchange Server, backup full Information Store on Exchange Server everyday.
All job backups run from Networker server or from client (Exchange Server) using command (nsrxchsv) are successful.
I need to restore a backup to new Exchange Server using command nsrxchrc. But i cannot see any parameter which point to backup data to restore.
Please show me the procedure to restore Exchange backup data to new server using command line (nsrxchrc).
Thanks a lot!
ble1
6 Operator
•
14.4K Posts
•
56.2K Points
0
September 17th, 2015 08:00
You can either use GUI or CLI. Command is explained in NME documentation. Note that NME module is no longer supported and you should ideally use NMM instead (note that NMM won't be able to restore backups made by NME).
jin1911
3 Posts
0
September 17th, 2015 09:00
Hi Hrvoje Crvelin,
Thanks for your comment.
I saw the procedure of the restore using GUI on NME Administration Guide, but the document has not the procedure use CLI.
For the CLI, it has only listing all parameter of nsrxchrc command. Please send to me the procedure of restore using CLI if you can.
Thanks a lot!
ble1
6 Operator
•
14.4K Posts
•
56.2K Points
0
September 17th, 2015 13:00
In NME admin guide there is chapter called "NetWorker Module recover commands". Both nsrxchrc and nsrxchmbrcwith description of each parameter. Because product is out of support you probably won't find it on support pages, but here is one of many online copies which you can easily dig up using google search: nsrd.info/documentation/modules/Exchange/Exchange_5_Admin.pdf
jin1911
3 Posts
0
September 17th, 2015 19:00
Thanks Hrvoje for your reply.
I know both nsrxchrc and nsrxchmbrc CLI with description of each parameter on Exchange_5_Admin.pdf document. But it has not procedure for restoring use CLI (to new server).
If you have any information about procedure to restore with CLI (to new server), pls send to me. Thanks a lot.
ble1
6 Operator
•
14.4K Posts
•
56.2K Points
0
September 18th, 2015 11:00
I didn't do this to new server so I don't know if there are any MS limitations. But if we assume there are not, you would run CLI command from new server, but you would specify with -c that you are using index of old server. You would need to put new client to remote access list of old client to allow it to read the index. There might be few requirements like creating structure or DB as it was on old server in Exchange - I really don't know that part. Actually, in document I pointed out, there is section for directed recovery which covers conditions you have. You would probably get much better answer if you have asked this question in NetWorker Support forum instead of here.