user audit logs

Question

Need to configure auditing of configurational changes done in NW environment by different users. Do we have such option in Networker where we can trace which user was loggedin and who has done any configuration change in the setup.

Panwar · Accepted Answer

Hi, Please refer the below KB article link. It will guide you to enable the rap.log on the NetWorker server http://solutions.emc.com/EMCSolutionView.asp?id=esg107154&usertype=C Regards Panwar

ble1 · Answer

rap.log (enabled as RAP logging in server properties)

ShubhamMishra · Answer

Hi All,

I have configured the same, can i get notifications of the same in my email.

for e.g: if someone changes the NMC administration password, I should get an email alert for the same... is that possible...

Thanks

ShubhamMishra · Answer

Hi All,

I have configured the same, can i get notifications of the same in my email.

for e.g: if someone changes the NMC administration password, I should get an email alert for the same... is that possible...

Thanks

SurajPujari · Answer

Hi Shubham,

Not sure if you can get an alert for any change done on any of the resource, but yes you can collate a report which can tell you what all changes have happened using DPA which will give you a report in easy to read format. Else you will have to define a script which tracks user initiated changes happening on that file and shoot an email.

mkeil · Answer

Hi, you can also try gstclreport to run NMC reports (User Audit) and handle the notification in a script. mkeil

NetWorker

user audit logs

Was this post helpful?