CLI syntax differences between powerconnect and N3000 series

Question

Just checking to see if there are any syntax differences between the configuration commands on a Dell N3000 switch versus the venerable PowerConnect 6200 series.  The latter is baked into my brain, but have not had the opportunity to work with an N3000 switch yet.  Any insight would be appreciated.

DELL-Josh Cr · Answer

Hi sketchy000,

They have similar commands, most of them are the same, but there are some syntax differences and new commands. ftp://ftp.dell.com/Manuals/all-products/esuprt_ser_stor_net/esuprt_networking/esuprt_net_fxd_prt_swtchs/networking-n3000-series_Deployment%20Guide4_en-us.pdf

Networking General

Was this post helpful?