Dell Networking N3024 and Dell Networking N2024P Trunking using GUI.

Question

I am new here for using dell.

I have Mikrotik CCR1036 Connected to Internet, I have a Dell Networking 3024, Then I have 5 Dell Networking N2024P deploying In each floors. I also have 20 Dell Networking X1026P for each Departments in a building. I have 2 network cable go to each floors.

Here is My Network Structure

Internet --> Mikrotik CCR1036 --> VLAN Trunk Dell Networking N3024 --> VLAN Trunk Dell Networking N2024P -->VLAN Access Dell Networking X1026P --> All PC

MY Question are:

Can you guide me with GUI Configuration

1- Can I use VLAN Trunk between Mikrotik and Dell Networking N3024?

2- How to trunk Dell Networking N3024 with Dell Networking 2024P with my 2 network cables?

3- Can I use 2 cables as failover using LAG? AND how to use LAG with VLAN Trunk?

4- Can you recommend me of best practices of using all my network devices above if It is bad?

nimsambath · Answer

There must be 20 VLAN in the building, VLAN1 to VLAN20. VLAN1 - 192.168.1.1 VLAN2 - 192.168.2.1 VLAN3 - 192.168.3.1 || || VLAN20 - 192.168.20.1

nimsambath · Answer

Where are Dell support? I posted it for 2 days, But still not get any help from Dell, It is very bad support, For Ubiquiti, I can ask questions anytime. I read User Guide many time about VLAN and I try many time, It didn't work, So I decide to post here for any help.

Can anyone help me, How to use VLAN Trunk with LAG?

Networking General

Dell Networking N3024 and Dell Networking N2024P Trunking using GUI.

Was this post helpful?