Unsolved
1 Rookie
•
8 Posts
0
965
July 21st, 2020 02:00
L3 interface in N3024 switch
Hi all,
I want to set an interface to an L3 switch but it seems is not able to do it like the S3124.
with the command, no switch port then follow by IP address
In N3024, it doesn't seem to allow the IP addresses to be configured on the interface.
No Events found!
DELL-Josh Cr
Moderator
•
9.6K Posts
•
42.4K Points
0
July 21st, 2020 09:00
Hi Owen,
That is right, it has to be assigned to a VLAN. Page 2051 https://dell.to/30yYLNx
DELL-Josh Cr
Moderator
•
9.6K Posts
•
42.4K Points
0
July 21st, 2020 17:00
Is there a reason why you are using layer 3? Are they going over a WAN?
owen1991
1 Rookie
•
8 Posts
0
July 21st, 2020 17:00
Hi Josh,
Will it affects my routing, cause I intend to connect my N3024 to S3124
On S3124 the port is L3 port with IP address of 10.1.1.1/30
On N3024 can the access port communicate with a L3 port?
owen1991
1 Rookie
•
8 Posts
0
July 22nd, 2020 18:00
No, it two offices apart by 4 levels apart.
S3124 connects to the MPLS network
N3024 is at Warehouse.
DELL-Josh Cr
Moderator
•
9.6K Posts
•
42.4K Points
0
July 23rd, 2020 09:00
It is going to depend on how you have things configured but they probably will be able to communicate over layer 2.
owen1991
1 Rookie
•
8 Posts
0
July 23rd, 2020 18:00
does the new firmware support L3 on an interface for N3024?
DELL-Josh Cr
Moderator
•
9.6K Posts
•
42.4K Points
0
July 24th, 2020 06:00
No it doesn’t, you would have to replace the switch with another S 3100.