N4032: VLAN and OOB config

Hello,

 

I think I do really not understand some net concepts.

I am trying to configure a N4032 switch, I made a soft-reset from a previous configuration. Now I can access via minicom and config it, but I am not able to access via HTTP and I assume it is because I am mixing some base concepts.

 

this is a scheme of what I'm want to do:

|----- iDRAC ----- ¿ ?
|
|--------------------| interface em1 --- public IP (assigned)
| LOGIN NODE  |
|--------------------| interface em2 --- 10.1.1.1/24
                                         em2:0 - 192.168.0.1/24 ---|
                                                                                  |
|--------------------| port_1 < ---    eth    --- > em2 --------|
|    SWITCH      |
|--------------------|

 

I though i needed a VLAN for the OOB like 192.168.0/24 segment, then assign an IP for each device and connect them via Switch but now, I think this is not the way ...

 

I don't know how to configure the switch for access via HTTP, I tryied this link:

https://www.dell.com/support/article/es/es/esbsdt1/how10399/how-to-set-up-management-access-for-dell-networking-n2000-n3000-and-n4000-series-switches?lang=en

 

but since I set it wrong it says that VLAN1 and OOB cannot be at the same segment.

 

I wanted 192.168.0.X be the "OOB" net and I assigned 192.168.0.2 to the switch but I cannot access to the HTTP client.

I just want to have a 10.1.1.0/24 segment for service and know how OOB works in order to connect to iDracs and the switch's client.

 

thanks all,

 

Sergio