This post is more than 5 years old
1 Rookie
•
33 Posts
0
1385
April 28th, 2020 13:00
N4032F OOB Interface VLAN tagging or untagged only?
I am configuring the oob mgmt interface on my n4032f switches. Can I use a VLAN for these interfaces or are they untagged only?
No Events found!
DELL-Josh Cr
Community Manager
•
9.6K Posts
•
43K Points
0
April 29th, 2020 15:00
You’re right, I only see it for ipv6.
DELL-Josh Cr
Community Manager
•
9.6K Posts
•
43K Points
0
April 28th, 2020 17:00
Hi,
Untagged, but you can set a vlan and it is not routable. Page 220 https://dell.to/35kTqeL
mike4fg
1 Rookie
•
33 Posts
0
April 29th, 2020 11:00
Thanks, I was able to get it working, but I had to use the GUI to set the gateway for the oob interface. Is there a cli command to set the gateway for the oob interface?
DELL-Josh Cr
Community Manager
•
9.6K Posts
•
43K Points
0
April 29th, 2020 11:00
you should be able to select the oob interface like any other port and then use the ip address command.
mike4fg
1 Rookie
•
33 Posts
0
April 29th, 2020 15:00
I only see examples for setting the ip address and subnet mask, not the gateway. Can you share an example of using the ip address command to set the gateway on the oob interface?
mike4fg
1 Rookie
•
33 Posts
0
April 30th, 2020 07:00
I'll mark this as answered. Can you please put in a ticket or feature request to get the 'configure gateway' function added for IPv4 oob config?
DELL-Josh Cr
Community Manager
•
9.6K Posts
•
43K Points
0
April 30th, 2020 09:00
Yes I will pass it along.