Hi

Hi have two dell powerconnect N2048 where i want to configure private vlan.

These two switchs are interconnected through 2 force10 4048-ON.

On the two powerconnect i have some vlans. 

i want to transform one vlan in a private vlan. 

the problem is that i can't make a trunk between one force10 and one N2048

when i want to configure the port channel between them by typing 

conf t

interface po35

switchport mode private-vlan trunk

I got the following messages

 % Error: Po 35 Port is part of a non-default VLAN

indeed there s another vlan tagged on this prot channel as the switch serves other vlan than just

the private one.

I m a bit puzzled. .