I have two stacked S4048 switches.  When the command show ip interface brief is issued ports Te1/5-8 are missing.

Interface IP-Address OK Method Status Protocol
TenGigabitEthernet 1/1 unassigned NO Manual up down
TenGigabitEthernet 1/2 unassigned NO Manual up down
TenGigabitEthernet 1/3 unassigned NO Manual up down
TenGigabitEthernet 1/4 unassigned NO Manual up down
TenGigabitEthernet 1/9 unassigned NO Manual administratively down down
TenGigabitEthernet 1/10 unassigned NO Manual up down

 

(conf)#int te1/5
^
% Error: Value out of range at "^" marker.

 

I have rebooted the device, no change.

 

Has anyone had this issue before?

 

Thanks!