sflow ingress/egress at the same time

Question

Hi, We have several Z9100/Z9264F - running OS9/OS10 and we want to enable sflow monitoring. Sflow works, except we cant enable ingress/egress at the same time. Seems we can enable only egress or ingress sflow on Interface. Is there a way to enable both (egress/ingress) at the same time? In Port config seems it keeps only state of one (egress/ingress)     [1] LRT-SDN-R02-Dell-Z9100(conf-if-po-103)#show config ! interface Port-channel 103  no ip address  mtu 9416  switchport  channel-member hundredGigE 1/7,1/8,1/9  no shutdown LRT-SDN-R02-Dell-Z9100(conf-if-po-103)#sflow enable LRT-SDN-R02-Dell-Z9100(conf-if-po-103)#show config ! interface Port-channel 103  no ip address  mtu 9416  switchport  channel-member hundredGigE 1/7,1/8,1/9  sflow enable  no shutdown LRT-SDN-R02-Dell-Z9100(conf-if-po-103)#sflow ingress-enable LRT-SDN-R02-Dell-Z9100(conf-if-po-103)#show config ! interface Port-channel 103  no ip address  mtu 9416  switchport  channel-member hundredGigE 1/7,1/8,1/9  sflow ingress-enable  no shutdown

DELL-Young E · Answer

Hello. https://dell.to/3UPWkk2   sFlow supports only one direction (either Egress or Ingress) at a time, from what I saw. I hope this helps.

Networking General

Was this post helpful?