'show interfaces trunk' m6220 command

Question

Is there an equivalent command on m6220 switch for 'show interfaces trunk' which works on Cisco?   I want to be able to see all the ports associated with trunk mode and which vlans they allow and are not pruned. The Cisco output looks like below:   m6220ca.example.com>show interfaces trunk Port Mode Encapsulation Status Native vlan Fa0/18 on 802.1q trunking 1 Port Vlans allowed on trunk Fa0/18 1-1005 Port Vlans allowed and active in management domain Fa0/18 1,101 Port Vlans in spanning tree forwarding state and not pruned Fa0/18 1,101 Thank you for your assistance!

DELL-Josh Cr · Accepted Answer

Hi,

If you use the show vlan command it will tell you which ports pass that vlan. Page 820 https://downloads.dell.com/manuals/common/powerconnect-m6220_reference%20guide_en-us.pdf

Show interfaces detail gives similar information about the VLANs on a port. Page 425.

KarsTharkas · Answer

show vlan | grep T   Make sure you have a CAPITAL T

Networking General

Was this post helpful?