Unsolved
2 Posts
0
2509
July 28th, 2021 10:00
Show running-config detail vs summarized
I have an older PoE switch (3548P) where when I run the switch# sh running-config command, it summarizes the config using interface ranges in the output - this is fine, except that I need a detail "per port" to begin redefining how I want to set this switch and it is much easier (although longer) to have a detailed running config that isn't summarized. I come from a Cisco background, however, our other two Dell switch models do show a detailed per port config. Thanks all~
No Events found!
DELL-Josh Cr
Community Manager
•
9.7K Posts
•
43.2K Points
0
July 28th, 2021 15:00
Hi,
I do not see a way to do it as part of the show running-config. Just to go port by port with show interfaces switchport page 501 https://dell.to/3l7uukM
JMartin2021
2 Posts
0
August 5th, 2021 11:00
Thank you Josh -
They are definitely older switches so will just have to see if we can work that way since having to show port by port for 3 stacked switches isn't exactly efficient -
Pretty sure I am at the latest software rev since I was hoping that would have been fixed in a more recent release-
thx
Jeff