Update firmware and cant access web gui now

Hi,

Try connecting to the console and see if it will let you login. https://dell.to/3JDsKto

I have them configured through CLI now, but still cant access via http.

Hi, Could you try to reset via pinhole "X1052 switch, the reset button is located on the back of the switch. The Reset button is a tiny pin hole with the word RESET printed next to it. A paperclip can be used to press the button." "To reboot the switch, press the Reset button through the pinhole on the switch for less than seven seconds" https://dell.to/334LRvF

Hope that helps!

@Dell-ErmanO I have reset these that way several times. Reconfigured and still no gui. If its not possible that they can be rolled back through CLI then I will just replace them with a different brand. Switches should never be this finicky. Not happy with any of the Dell switches we have. Hopefully replace them in 6 months.

I have 4x total 1052s that are on 3.0.1.9 firmware. 

You might be able to put the older firmware on a USB stick and use the auto firmware update function if you factory reset again. Page 88 https://dell.to/3zvuosm

Just wondering if you had any luck rolling back your switches in the CLI. I am having similar issues to what you have described and tried rolling back but it keeps wanting to load the newer firmware.  

Use https infront of the IP
https://<IP>

@Prajval.A_m​ I was having the same issue and this was the solution for me. 

Thank you!

@Prajval.A_m​ also a thanks from me! just upgraded and I thought it had hosed the web ui.