Unsolved
This post is more than 5 years old
4 Posts
0
10981
October 3rd, 2005 03:00
Wireless connection drops frequently
I've got a 600m with the integrated 802.11B internal adapter. It worked very well for a couple years. Recently it started periodicly dropping the connection to the WAP. Signal strength is good. It always connects at boot but after a few minutes the connection will be lost. Sometimes it comes back. Sometimes it doesn't. Turning the adapter off and then on again always gets the connection back. My work laptop sits close by and never drops off line.
The system is out of warranty. What do you folks think I should do next?
No Events found!


jmwills
2 Intern
•
12K Posts
0
October 3rd, 2005 08:00
Check the Power Management tab on the device. It may be as simple as being set to "allow to turn off the device to save power". Right click the adapter and go to properties and look in the Power Management Tab settings.
Do you have the most current driver installed?
gbarn88347
41 Posts
0
October 5th, 2005 18:00
Ron Weiss
24 Posts
0
October 8th, 2005 18:00
Ok, I might just be a believer, "gbarn88347" might have found the solution to the dropping of the network connection with the Intel 2200 bg mini pci wifi card.
It's been a few days and no drops!
Usually I get 3-4 lost connections a day, sometimes de-installing the card works, but usually I'm forced to reboot to get back on line.
Will get back to the forum next week with my final verdict, thanks gbarn !
ron w.
Ron Weiss
24 Posts
0
October 9th, 2005 01:00
I use Zone Alarm as well and by default, disables the internal fire wall in windows, but even though it's not running, un-checking the wi-fi option resolved my issue of losing the connection. So far it's been two days error free, the first time since owning the 700m that it held it's wi-fi link without an drop.
Just go to the Advanced tab under Properties for the 2200BG, select settings for Windows Firewall and uncheck the wi-fi box under the advanced tab. Give it a shot, nothing too lose.
Ron W.
Message Edited by Ron Weiss on 10-08-2005 09:42 PM
waelwell
4 Posts
0
October 9th, 2005 01:00
Well, I'm using Zone Alarm and the Windows firewall is deactivated. But I'll try the rough equivalent inside Zone Alarm.
However, I'm starting to believe that my problem may be some sort of very localized disruption. My work laptop that sits a foot away almost never drops out. If I take my Dell into a different room to work, the connection is great. It just seems that when I put the laptop in one particular part of my desk the signal strength varies from full strength to nothing and back again.
waelwell
4 Posts
0
October 9th, 2005 15:00
Well... I've got a 600M with a 2100 adapter and nothing is mentioned about the firewall on the advanced tab (or any other tab) of the adapter properties page. :smileysad:
gbarn88347
41 Posts
0
October 9th, 2005 17:00
the check boxes are in the windows firewall settings not the wyfi card settings
start > control panel> security centre> windows firewall > advanced untict wyfi tick box
sales@thurcastonwebsites.com for more info
VBdotNet
415 Posts
0
October 10th, 2005 20:00