Unsolved
This post is more than 5 years old
10 Posts
0
32898
May 9th, 2009 12:00
m1000e....iKVM switch
I have a m1000e blade chassis w/ iKVM switch. I understand one usb is for mouse, one for keyboard and then the monitor input. What is the ethernet connection for? I can't seem to get any sort of connection from it.
thx
No Events found!
tommo666
4 Apprentice
•
1.2K Posts
0
May 10th, 2009 08:00
THis is a note from a manual i have, It is used to connect to another dell/avocent KVM
The RJ-45 connector and uses Cat5 (or better) cabling, it is not an Ethernet network interface port. It is only used for connection to external KVM switches with Analog Rack Interface (ARI) ports.
Avocent
104 Posts
0
June 3rd, 2009 01:00
The CAT5 ethernet port is used to connect to external (Dell KVM switches or Avocent branded KVM switches only). A single CAT5 cable is needed to connect between both the iKVM card and the external switch. The link below has the supported Dell branded KVM switches:
http://dell.avocent.com
pzero
1 Rookie
•
108 Posts
0
February 18th, 2011 04:00
So the M1000e iKVM by default only supports local access and you need an external KVM switch to access it remotely over the network?
Thanks.