10 Posts
0
1556
October 21st, 2021 21:00
R900 Server does not shut off with power button.
I just got a used/refub server to help me understand enterprise training better. I got a Power-edge R900, I know its older but I still want to learn more. I come from the home small business side and need more server training. upon booting up the first time ran into minor problems because items needed to be re-seated after shipping. I did all that and booted up. went to bios and checked everything, told it to restart, it did and I even setup a raid with 2 drives.
However, after getting everything configured, I am waiting on my OS CD to arrive and I decided to just shut the server off till it gets here, but....
The power button does not shut the server off...??? I even held it in for 30 seconds, then a minute. ..? nothing. I pulled both power cords to manual disconnect, then re-plugged them, system came on immediately and booted. I tried again with the power button, it refuses to shut down???? I read half the manual but everything in there says the power button will shut the server off.
Any Ideas?
DELL-Shine K
6 Operator
•
3K Posts
1
October 21st, 2021 21:00
There are BIOS setting which can disable power button and decide the state of the server when power cable connected. You can check those settings to see whether power button is disabled.
You can refer "System Security Screen" section on page 48 of below link for more details on these BIOS settings. "Power Button" and "AC Power Recovery" are the 2 setting which you need to check
https://downloads.dell.com/manuals/all-products/esuprt_ser_stor_net/esuprt_poweredge/poweredge-r900_owner%27s%20manual_en-us.pdf
Dell- Maria J
4 Apprentice
•
278 Posts
0
October 22nd, 2021 02:00
Hello wdmagic,
Thank you for choosing Dell.
I absolutely agree with troubleshooting steps, provided by Shine K. Could you please check it?
More information about "AC Power Recovery" you can find in this knowledge base article: https://dell.to/3b0UAQs
Please ask me, if you have any questions.
Thank you.
Maria Januszka
#IWork4Dell
Dell | Social Outreach Services - Enterprise
wdmagic
10 Posts
0
October 22nd, 2021 20:00
I was staying away from anything to do with security that's why I never saw it. but it was disabled, so thanks so much. also thanks for giving the page in the manual also. its working fine now.
Now I get to post my next questions....