This post is more than 5 years old
1 Rookie
•
13 Posts
0
11673
December 9th, 2016 16:00
Persistent "Failure predicted" error after drive replacement
We have a PowerEdge T320 with a 3-disk RAID 5 array attached to a PERC H310 adapter. The amber light on one of the disks started flashing and OpenMange said that there was a "non-critical" error with "Failure predicted" showing Yes.
I took the disk offline, swapped it out , and let the array rebuild, and the error persists. So I did it again, with another new disk, with the same result.
Ideas? Something obvious I'm missing?
No Events found!
rcharbon
1 Rookie
•
13 Posts
0
December 16th, 2016 12:00
We updated a bunch of firmware, drivers, bios and the predictive failure error is cleared.
rcharbon
1 Rookie
•
13 Posts
0
December 10th, 2016 04:00
FYI, a Consistency Check is currently running on the array.
rcharbon
1 Rookie
•
13 Posts
0
December 12th, 2016 03:00
...and the predicted failure persists after the check is complete.
rcharbon
1 Rookie
•
13 Posts
0
December 12th, 2016 12:00
Didn't see an email, and I can't post the 17MB report here ;-)
You can get it here:
XXX DSET link deleted by moderator due to security reasons XXXX
Let me know when you have it.
rcharbon
1 Rookie
•
13 Posts
0
December 12th, 2016 18:00
The problem is PD02 on VD01. The server has been rebooted. Why would replacing the drive for a THIRD time be a good idea?
rcharbon
1 Rookie
•
13 Posts
0
December 14th, 2016 04:00
We will have to schedule some downtime.