Unsolved
This post is more than 5 years old
1 Message
0
2752
February 21st, 2008 03:00
Power Edge 2900 with Perc 5/i using Netware 6.5
I am trying to use the Array Manager with my Power Edge 2900 with Perc 5/i using Netware 6.5 but the instalation fails due to not having the PERC2.ham or PEDGE3.ham driver loaded.
The Netware driver for the Perc 5/i is mega_sas.ham
Is there any way to use the Dell array manager with this setup?
It would appear that there is no support for the DELL OMSA with Netware 6.5.
Message Edited by l-luggy on 02-21-2008 12:28 AM
No Events found!
DELL-GaryS
777 Posts
0
February 21st, 2008 19:00
Hi I-luggy,
Per the manual supported O/S <ADMIN NOTE: Broken link has been removed from this post by Dell> Netware is not supported under the PERC 5 series, therefore I do not have any tested and certified drivers to get the OMSA S/W to work for this controller under NW 6.5. There might be ways to do remote management of the RAID using a 2nd system with a supported O/S, but that'd be a question for folks in the systems management area. Sorry to punt this, perhaps somebody else has gotten this to work and would care to share their procedures with us.
Regards,
Dell-GaryS