Unsolved
2 Posts
0
601
October 4th, 2022 09:00
Raid6 rebuild
I had a drive die in my T630 and I’ve got another drive that’s got a smart error. I shut the server down and replaced the drive that was failed first. I booted into the raid controller via BIOS and it’s moving super slow between the tabs. When I go to the PD Mgmt screen is shows my disk in rebuild state but the lights are blinking very slow (I’m use to seeing them flashing fast for a rebuild) .. on the Properties tab it says for the Perc H730 the status is Needs Attention. How can i tell if it's really rebuilding the drive and will it show the percentage?
No Events found!
DELL-Young E
Moderator
•
5.4K Posts
•
37 Points
0
October 4th, 2022 16:00
Hi, thanks for choosing Dell. I don’t know what OS you’re on but I think you can check that by installing OMSA. And can you access IDRAC?
You can also check the rebuilding status by looking at HDD LED.
Dell Enterprise HDD : What is the meaning of LED on Physical Drives (PD) ?
https://dell.to/3M3zqTn
anthony.jones
2 Posts
0
October 5th, 2022 04:00
Server 2019. I am currently connected to iDRAC and its booted to the raid controller. Status is set to rebuild, but I dont see where I can tell the progress. The light is a slow blink green.