Unsolved
1 Message
0
78
November 28th, 2022 06:00
Servidor r520
I have a problem with the R520 server, I added 6 disks of 1tb Sata and gives me an error that says:
drive mismath detected for drive 3 in bay 1 install correct drive type, the server stays configured memory and does not move forward, what can I do?
No Events found!
DELL-Charles R
Moderator
•
4.7K Posts
•
25.5K Points
0
November 28th, 2022 11:00
Hello Tatiana.120100,
Is this a new install or existing one that was working? Can you provide some history of the server?
Do you have a mix of SAS and SATA drives?
:for example a SATA disk will not operate in an array containing SAS drives and vice versa.
Can you verify you have all compatible drives?
To start with I have a couple initial steps I can recommend:
-Do a flea power drain and check results.
-If you still have issue clear the NVRAM and check results.
drain flea power (shut down, disconnect power cables and Network cables, hold in power button 20 seconds with cords removed). After flea power drain, system has to set for 3 minutes for DRAC to reset without any power plugged in, then plug in NIC and power but wait 2 minutes before power on to give DRAC time to initialize. Check results
Clear NVRAM - there is a map under the lid to show the jumper location. Shut down, Set jumper to the Clear position, power on and Post up to the jumper error, shut down and return jumper to original location. Check results