Event ID 10010 SOURCE: DCOM

Event 10010
SOURCE: DCOM

DESCRIPTION: The server {9B9A80E0-A9C0-11D2-B5E1-006008187232}
did not register with DCOM within the required timeout.

When searching thru my server's registry the GUID (Global Unique Identifier) references
"VxVmCmd Command line Server".

I then ran DCOMCNFG from the command prompt to look at all the applications DCOM was
associated with and found "VxVmCmd Command line Server".  Highlighted that and clicked
on "Properties".  It gave me the message "The operation completed successfully". 
When I hit "Okay", it opened a box "VxVmCmd Command line Server Properties". 
Under the "Location" tab there are two boxes, both unchecked.  I checked the one entitled
"Run application on the computer where the data is located".
(The other one was "Run application on the following computer:" and it gave you a
browse button.  Left that one unchecked.).  Exited out and rebooted. 
Made no difference...still got Event 10010.  Turned it over to Dell Software Support....haven't heard back yet.

Any ideas??

Message Edited by skeeterlogan on 11-24-2003 06:15 PM