UNSOLVED
Deploy ScaleIO 1.31 on vSphere 5.5 "always" can't finished
Environment :
ScaleIO 1.31
ESXi 5.5
vCenter 5.5
1. I have one time that almost finish deploy ScaleIO on vSphere.
But I encounter the below 3 failed task, I don't how to solve it.
finially, I rollback.
2. Below status occur many times, I rollback deploy process when I encounter this kind of status.
I try to login 3 SVM check the status, I still can't find out what's problem,
is anyone how to solve or where can find the detail log message, thanks.
953
0
Posted June 11th, 2015 02:00
Are you using different network then management network?
If yes, have you created vmkernel?
953
0
Posted June 11th, 2015 02:00
Hi Alexkh,
Thanks for your reply, your instruction that I have done before my every time reinstallation.
Is any other deploy detail log messages can help me to find out, thanks.
953
0
Posted June 11th, 2015 19:00
Hi alexkh,
my vsphere network config as below,
1 * standard switch
SIO_MGMT virtual port group for ScaleIO management network (192.168.36.x)
SIO_Data virtual port group for ScaleIO data network (10.0.0.x)
953
0
Posted June 16th, 2015 20:00
harry1688 are these two networks routable to each other? I assume your VC host is the VC6-New. Is this vCenter 6 or 5.5 as you stated?
953
0
Posted June 16th, 2015 20:00
Hi chisoxhowe,
acturally, two network port group were on the same network, so it can reach each other. vCenter 5.5 version, thanks.
953
0
Posted June 16th, 2015 21:00
I just noticed that you stated 1.31. Is this correct? If so can, can you try deploying with the latest 1.32?
953
0
Posted June 17th, 2015 00:00
The best option will be creating another vmkernel in your 10.* network, so SDC would be able to connect to the MDM without going through gateways.
Please login to the ESC host (ssh) and try to ping the SVM on 10.* network
alexkh
60 Posts
953
0
Posted June 11th, 2015 01:00
Please wipe out the installation, then login to each ESX server (using ssh) and run the following command:
cat /etc/vmware/esx.conf| grep scini
if the output is not empty, please edit the file /etc/vmware/esx.conf and remove all the lines that contain scini.
reboot the servers.
retry the installation