Help Identifying PowerVault 200S Enclosure Module

Question

I would like to setup a cluster configuration with my PowerVault 200S but am experiencing some difficulty determining if the enclousre modules I have are cluster-capable.

The enclosure modules I have are:
3065E CARD (CIRCUIT), CONTROLLER, SCSI (SMALL COMPUTER SYSTEMS INTERFACE), INPUT/OUTPUT, ENCL-SRV, EXPANDABLE SYSTEM

Are these modules cluster-capable? Thank you in advance for any assistance.

Cheers!
Dave Bey

Dev Mgr · Answer

What does the sticker say that's next to the scsi connector on the scsi module? (the module type can be determined by that sticker).

FOURIER · Answer

I am confused with Dev Mgr response, what sticker, the black one or the white one, does it matter? One would have U320 or U160 right (black sticker), the other would have some part numbers as well as where it was made (white sticker).

You would have to look at the setting on the middle module, one would be single, split and joined bus mode.....

IFF your setting up a MSCS, ensure that you set the appropriate ID's on the PERC adapters and make sure you follow the best practices for running your Microsoft Cluster.

Dev Mgr · Answer

The sticker should say something along the lines of EXM, ESEM, SMM or SEMM. These are the controller types available for the PV200S. They determine if the unit can be used for clustering or not.

B_Segurson · Answer

The sticker should be on the outside sufrace of the connector bulkhead, near one of the SCSI connectors.   Only SEMM is used for clustering.

Dev Mgr · Answer

I'm not 100% sure, but I think that partnumber (3065E) is an ESEM.

DaveBey · Answer

The only sticker I have on either module is a dark yellow one that says DP/N0003065E- 13260- 91?-A1?? Rev A00. The ? is different on both modules. The only writing next to the SCSI connector is etched in the metal casing and it says SCSI LVD/SE. There is a white sticker on the circuit board that says P/N PCA-500500 Rev 0.9 if that helps.

Cheers!
Dave Bey

PowerVault

Help Identifying PowerVault 200S Enclosure Module

Was this post helpful?