Unsolved
This post is more than 5 years old
4 Posts
0
4178
October 25th, 2005 17:00
Replace Quantum DLT4000 Tape Backup
I have a deffective internal quantum DLT400 tape drive that I am trying to replace with a new quantum DLT VS160. The PowerEdge 4400 server is not able to detect the new tape drive (VS160) after startup. I made sure that the SCSI ID is changed to 6 on the the drive and using the same cable which is terminated, but still no success. Is there something that I am missing here?
p.s. the tape drive was detected fine on a different server (PowerEdge 4600)
No Events found!
DELL-Bob D
899 Posts
0
October 28th, 2005 18:00
anaSoft
4 Posts
0
October 28th, 2005 18:00
The tape drive does not show up during server POST. It is attached to the integrated Adaptec AIC-7880 Ultra/Wide SCSI secondary host adapter.
I just found out from quantum technical support that the AIC-7880 controller is not compatible with the VS160 tape drive. They suggested that I get an AHA-29160 scsi card to get the vs160 to work on this system.
DELL-Bob D
899 Posts
0
October 31st, 2005 13:00
You will need another adapter.
The 7880 was integrated into the server as a narrow controller. You have a wide device, you will want another controller.
Message Edited by Dell-Bob D on 10-31-2005 09:24 AM