This post is more than 5 years old
1 Rookie
•
23 Posts
0
42930
September 11th, 2011 21:00
Second EMM - Partially Managed Storage Array
Hi Guys,
Anotehr quick one:
Setting up a MD3200i and playing around with various configs and somewhere along the lines the main EMM module doesn't seem to be working properly. The port son both EMM are setup correctly, there are no errors in the MD3200i logs all the reports and config areas all say its conencted and working.....but I cannot access the management port and the Array comes up with a message about it being 'Partially managed' when you access it. I have removed the array and added it back in manually and automagically and everytime the primary EMM is not accessible.
In the MD Storage Manager I can see it adn change IP's on it - but its still not accessible.
Any ideas??
Daver19_1df901
1 Rookie
•
23 Posts
1
September 12th, 2011 18:00
All good - spoke with ProSupport, needed to pull out the affected EMM whils thte MD3200i was still on, wait for all the lights to go out on the EMM then put it back in. I then rebooted the MD3200i after about a minute and it came up good as gold ;)
Daver19_1df901
1 Rookie
•
23 Posts
0
September 11th, 2011 21:00
Number of RAID controller modules: 2
RAID Controller Module in Enclosure 0, Slot 0
Status: Online
Current configuration
Firmware version: 07.75.14.62
Appware version: 07.75.14.62
Bootware version: 07.75.14.62
NVSRAM version: N26X0-770890-007
Pending configuration
Firmware version: None
Appware version: None
Bootware version: None
NVSRAM version: None
Transferred on: None
Model name: 2650
Board ID: 2660
Submodel ID: 143
Product ID: MD32xxi
Revision: 0775
Replacement part number: A00
Part number: 0770D8
Serial number: 13Q0034
Vendor: DELL
Date of manufacture: 4 April 2011
Trunking supported: No
Data Cache
Total present: 1744 MB
Total used: 1744 MB
Processor cache:
Total present: 304 MB
Cache Backup Device
Status: Optimal
Type: SD flash physical disk
Location: RAID Controller Module 0, Connector USB 1
Capacity: 7,639 MB
Product ID: Not Available
Part number: Not Available
Serial number: 0000115c
Revision level: 10
Manufacturer: Lexar
Date of manufacture: 1 December 2010
Host Interface Board
Status: Optimal
Location: Slot 1
Type: iSCSI
Number of ports: 4
Board ID: 0501
Replacement part number: PN 0770D8A00
Part number: PN 0770D8
Serial number: SN 13Q0034
Vendor: VN 13740
Date of manufacture: Not available
Date/Time: Mon Sep 12 13:35:07 EST 2011
Associated Virtual Disks (* = Preferred Owner): None
RAID Controller Module DNS/Network name: 5FM692S
Remote login: Disabled
Ethernet port: 1
Link status: Up
MAC address: 78:2b:cb:2b:d8:20
Negotiation mode: Auto-negotiate
Port speed: 1000 Mbps
Duplex mode: Full duplex
Network configuration: Static
IP address: 10.0.10.200
Subnet mask: 255.255.255.0
Gateway: 10.0.10.254
Physical Disk interface: SAS
Channel: 1
Port: Out
Status: Up
Maximum data rate: 6 Gbps
Current data rate: 6 Gbps
Physical Disk interface: SAS
Channel: 2
Port: Out
Status: Up
Maximum data rate: 6 Gbps
Current data rate: 6 Gbps
Host Interface(s): Unable to retrieve latest data; using last known state.
Lists drives from here down and I cut them....
RAID Controller Module in Enclosure 0, Slot 1
Status: Online
Current configuration
Firmware version: 07.75.14.62
Appware version: 07.75.14.62
Bootware version: 07.75.14.62
NVSRAM version: N26X0-770890-007
Pending configuration
Firmware version: None
Appware version: None
Bootware version: None
NVSRAM version: None
Transferred on: None
Model name: 2650
Board ID: 2660
Submodel ID: 143
Product ID: MD32xxi
Revision: 0775
Replacement part number: A00
Part number: 0770D8
Serial number: 15A004G
Vendor: DELL
Date of manufacture: 15 May 2011
Trunking supported: No
Data Cache
Total present: 1744 MB
Total used: 1744 MB
Processor cache:
Total present: 304 MB
Cache Backup Device
Status: Optimal
Type: SD flash physical disk
Location: RAID Controller Module 1, Connector USB 1
Capacity: 7,639 MB
Product ID: Not Available
Part number: Not Available
Serial number: a0030890
Revision level: 10
Manufacturer: Lexar
Date of manufacture: 1 February 2011
Host Interface Board
Status: Optimal
Location: Slot 1
Type: iSCSI
Number of ports: 4
Board ID: 0501
Replacement part number: PN 0770D8A00
Part number: PN 0770D8
Serial number: SN 15A004G
Vendor: VN 13740
Date of manufacture: Not available
Date/Time: Mon Sep 12 13:37:05 EST 2011
Associated Virtual Disks (* = Preferred Owner):
Exchange_Server_Storage*, Fileshare_Storage*, Server_Storage_1*,
Server_Storage_2*, Server_Storage_3*, Server_Storage_4*, VMOS-01*, VMOS-02*,
VMOS-03*, VMOS-04*, VMOS-05*, VMOS-06*
RAID Controller Module DNS/Network name: target
Remote login: Disabled
Ethernet port: 1
Link status: Up
MAC address: 78:2b:cb:37:62:49
Negotiation mode: Auto-negotiate
Port speed: 10 Mbps
Duplex mode: Half duplex
Network configuration: Static
IP address: 10.0.10.201
Subnet mask: 255.255.255.0
Gateway: 10.0.10.254
Physical Disk interface: SAS
Channel: 1
Port: Out
Status: Up
Maximum data rate: 6 Gbps
Current data rate: 6 Gbps
Physical Disk interface: SAS
Channel: 2
Port: Out
Status: Up
Maximum data rate: 6 Gbps
Current data rate: 6 Gbps
Daver19_1df901
1 Rookie
•
23 Posts
0
September 12th, 2011 00:00
Further testing - cannot ping the IP on that controller.....orange light on Nic connector - no flashing green at all.