I inherited a hand-me-down DELL V305 printer. THere is a new black cartridge but when it prints the page is blank and error message says to remove plastic. So I think the previous owner didn't remove and I take out cartridge but can't seem to find what 'plastic' needs to be removed. When I feel ink outlet it does seem to be covered but without moving the coppery thingy with coding I don't know what to do to get it uncovered :-( HELP!!!
If you unplug the printer from the wall and remove the power brick for 60 seconds, this will reset any error messages the printer has. I would then plug everything back in.
Power on the printer.
Open the printer(with the power on) and take out the Dell Series 9 black cartridge and then reseat it. I would then take out the color Dell Series 9 ink cartridge and reseat it. Now close the printer and it will print an alignment page.
Any error messages?
black cartridge = black side(left side) color cartridge = color side(right side)
photo cartridge = black side(left side) color cartridge = color side(right side)
Yes re Series 9 - powered down and powered up, reseated cartridges, machine when through motion of printing but came out blank. Error message says there is alignment problem. remove tape from cartridges. When I touch bottom of coloured cartridge I can feel where ink comes out bottom but on black cartridge the ink outlet does appear to be covered with film but I can't seem to find away to remove without damaging sensor tape
Sensor in both catridges, so both need some ink to print. You can tell it to use Black only, in printer preferences.
Can you copy a document under the glass? Black & white and color? If not, the problem is the printer, either the Dell Series ink cartridge(s) or the printhead. I have see a few of the print heads go out, the original failed at an early time, but the replacement printhead has made mine last for years.
THanks Rick - I'd say I have a faulty cartridge which is basically why previous owner got rid of printer, couldn't get it to work so turfed it. I'll go get a new cartridge. I'm assuming I don't have to replace empty coloured cartridge? I'm just needing b/w print.
PudgyOne
11 Legend
•
30315 Posts
•
106638 Points
750
0
Posted May 12th, 2013 10:00
Phiwie,
Are you using Dell Series 9 ink cartridges?
If you unplug the printer from the wall and remove the power brick for 60 seconds, this will reset any error messages the printer has. I would then plug everything back in.
Power on the printer.
Open the printer(with the power on) and take out the Dell Series 9 black cartridge and then reseat it. I would then take out the color Dell Series 9 ink cartridge and reseat it. Now close the printer and it will print an alignment page.
Any error messages?
black cartridge = black side(left side) color cartridge = color side(right side)
photo cartridge = black side(left side) color cartridge = color side(right side)
Dell Series 9 ink cartridges have a sensor in them that cannot be reset. Article on refilling Dell ink cartridges.
Dell Series 9 ink cartridges can be purchased at Staples, Walmart or Dell's Website.
It's possible to get a Dell Series 9 ink cartridge with a bad sensor. I would take these back to the place of purchase for a replacement.
Rick